Enabling Irrigation
In Edenic select your controller, navigate to Device Settings and select the 'Irrigation Settings' tab. Select the 'Irrigation Installed' checkbox to install and view irrigation settings for your IntelliDose. Remember to submit changes after configuring your IntelliDose irrigation settings.
Irrigation Mode - chose between:
- Single Output (for backwards compatibility – only one output is used for irrigation)
- Sequential (for single trigger and each irrigation station runs in turn)
- Independent irrigation (up to 4 irrigation stations with own triggers and durations)
Number of irrigation stations - 0 to 4, where 0 means no irrigation is configured
Separate pump output – indicate if a main pump output should be activated along with each station
Irrigation Mode - For each Irrigation Mode, you can specify whether the trigger is 'Irrigate at same time each day' OR 'Irrigate day and night' OR 'Irrigate during day only'.
If set to Independent, each irrigation station can be set to use a different duration and trigger:
Note: When using single output or sequential irrigation, only one irrigation trigger can be specified.
Wiring Diagram - The wiring diagram updates to accommodate the new irrigation scheme:
Independent Irrigation with four stations
IMPORTANT
When using sequential or independent irrigation stations and a Separate pump output there will be one additional output allocated to the irrigation pump. This is to accommodate the scenario where a single pump drives the irrigation while individual solenoid valves are operated for watering each station. This additional output is labelled as 'Irrig pump' on the wiring diagram and only needs to be used if using a single irrigation pump.
If individual irrigation pumps are used for watering each station then it is not necessary to use the Separate pump output.
Control Tab
Each independent irrigation station can be disabled or forced on:
For further information regarding the IntelliDose, check out the manual:
IntelliDose manual