Product guides / Get started
OnePen
pH Pen
Soil pH Pen
Conductivity Pen
Growers Toolbox
Truncheon Nutrient Meter
Combo Meter
Combo Meter Plus
Multimedia pH Meter
ORP/pH Meter
Pulse Meter and App
- How to calibrate the Bluelab Pulse Meter [+ video]
- What if I can't see my Pulse on the "Select Device" list?
- Understanding Nutrient Measurements with the Pulse Meter
- How do I give feedback on the Pulse app or request new features?
- Where is the Pulse measurement being taken from?
- Why are the conductivity measurements from my Pulse Meter different from my normal extraction tests?
- Does the Custom Media function of the Bluelab Pulse only calibrate the moisture content?
- Why can't I set my Pulse conductivity units to ppm?
- Why do the lights on the Pulse flash a few times before going solid?
- What maintenance is required for the Bluelab Pulse Meter?
- How do you turn the Pulse Meter on/off?
- Does the Bluelab Pulse Meter always measure all three readings; moisture, conductivity and temperature?
- I have just replaced my Pulse Meter battery but it keeps on restarting. How do I get it to run?
- Why does the Pulse app show “Stabilising” whenever a measurement is taken?
- Which base medium do I use on my Pulse app?
- With the Pulse Meter and app, how long will it take to create a custom calibrated medium?
- Is all my Pulse device data backed up?
- Why does the status bar on the measurement screen of my Pulse app say “Not Connected”?
- How accurate is the Bluelab Pulse Meter?
- How do I export my Pulse app data?
- Why can’t the Pulse app see my Pulse meter after pairing with it through Android/iOS?
- Do I need to calibrate the Bluelab Pulse Meter?
- How do I see what the settings were when a Pulse measurement was taken?
- How to take a measurement with the Bluelab Pulse Meter [+ video]
- Get started with the Bluelab Pulse Meter
- Pairing your Bluelab Pulse™ to Edenic
- Configure Pulse to medium type, nutrient range and moisture range
- How to calibrate the Bluelab Pulse Meter with Edenic [+ video]
- Troubleshooting Bluelab Pulse Meter connectivity problems
- Getting Started: Using your Bluelab Pulse™ with Edenic
- FAQ for the Bluelab Pulse Meter
Guardian
Pro Controller
PeriPod
Sample Tube and Fitting
pH Controller
Connect Stick 2
- Connect Stick can't be detected - "Detecting Connect stick..." Resolution 1: Installing driver
- Connect Stick can't be detected - "Detecting Connect stick..." Resolution 2: Enable the virtual COM port
- Connect Stick can't be detected - "Detecting Connect stick..." Resolution 3: Update the driver
- Bluelab Connect Stick 2 & Range Extender 2 - Setup